Service for industry & research partners

• Flow curve determination in the cylinder crush test with freely programmable thermodynamic cycle [Gleeble HDS-V40]
• Hot rolling simulation of flat products (flat upsetting test) [Gleeble HDS-V40]
• Hot rolling simulation of wire products (MaxStrain® test) [Gleeble HDS-V40]
• Simulation of hot rolling of flat products from the solidification heat (melting with subsequent flat upsetting test from the melting heat) [Gleeble HDS-V40]
• Continuous annealing tests under defined stress conditions with dilatometry on cold strip [Gleeble HDS-V40]
• Cylinder upsetting tests to determine flow curves [BÄHR DIL805 A/D, BÄHR MDS-830, Gleeble HDS-V40, WUMSI]
• Flat immersion tests to determine flow curves [Gleeble HDS-V40, WUMSI]
• Bending tests [WUMSI]
• Ring crush tests to determine flow curves for sheet metal [WUMSI]
• Ring crush tests to determine the coefficient of friction during cold rolling [WUMSI]
• Tensile test [AG 50/100/300]
• Torsion test [BÄHR MDS-830]
• Combination of tensile, compression and torsion test [BÄHR MDS-830]
• biaxial dilatometry for flat and cylindrical specimens [BÄHR BTA-840]
• Determination of formability at multi-axial stress state with the possibility of determining the phase transformation (via longitudinal and transverse change) [BÄHR BTA-840, BÄHR MDS-830]
• Determination of ZTA, ZTU and UZTU charts [BÄHR BTA-840, BÄHR DIL805 A/D, BÄHR MDS-830]